CORP STOP AWWA X COMP 3/4 INCH NL
Share
Product#AYW 74701BQ-00.75
MPN 5182-028
UPC053565346540
Description
A.Y. McDonald® Ball Valve Corporation Stops come standard with 360 deg operating head and are designed for low turning torques and high pressures (300 psig). The PTFE coated ball is supported by two blow-out proof EPDM seals. The end piece joint is sealed with an EPDM O-ring and thread locker. There is no metal-to-metal contact which causes high torques. The bubble-tight feature at 300 psig makes these valves a better choice than a plug valve when test or operating pressures over 100 psig are expected. All McDonald® Ball Valve Corporation Stops are available with a wide variety of end connections. They are made in the United States of America and are manufactured to meet or exceed the AWWA C800 (latest revision) standard, except where noted.
A.Y. McDonald Ball Corporation Stop, 3/4 in Nominal, AWWA/CC x Q CTS Compression, 300 psi, Full Port, Media: Water, Brass Ball, 1.39 in Top to Inlet Center, Brass Body, EPDM Softgoods, 3/4 in Dia
A.Y. McDonald Ball Corporation Stop, 3/4 in Nominal, AWWA/CC x Q CTS Compression, 300 psi, Full Port, Media: Water, Brass Ball, 1.39 in Top to Inlet Center, Brass Body, EPDM Softgoods, 3/4 in Dia
CORP STOP AWWA X COMP 3/4 INCH NL
Share
Product#AYW 74701BQ-00.75
MPN 5182-028
UPC053565346540
- Brand:Â A.Y. McDonaldBall Material:Â BrassBody Material:Â BrassDimensions:Â 3/4 in DiaEnd Style:Â AWWA/CC x Q CTS CompressionMedia:Â WaterNominal Size:Â 3/4 inPort Type:Â FullPressure Rating:Â 300 psiSeries:Â 74701BQSoftgoods Material:Â EPDMTop to Inlet Center:Â 1.39 in
- Blow-out proof EPDM port seals
- End piece joint sealed with an EPDM O-Ring and thread locker
- Insert stiffeners are required on all flexible plastic connections
- PTFE coated brass ball rotates 360 deg
- EPDM O-ring/port seal
- A.Y. McDonald® Ball Valve Corporation Stops come standard with 360 deg operating head and are designed for low turning torques and high pressures (300 psig). The PTFE coated ball is supported by two blow-out proof EPDM seals. The end piece joint is sealed with an EPDM O-ring and thread locker. There is no metal-to-metal contact which causes high torques. The bubble-tight feature at 300 psig makes these valves a better choice than a plug valve when test or operating pressures over 100 psig are expected. All McDonald® Ball Valve Corporation Stops are available with a wide variety of end connections. They are made in the United States of America and are manufactured to meet or exceed the AWWA C800 (latest revision) standard, except where noted.
A.Y. McDonald Ball Corporation Stop, 3/4 in Nominal, AWWA/CC x Q CTS Compression, 300 psi, Full Port, Media: Water, Brass Ball, 1.39 in Top to Inlet Center, Brass Body, EPDM Softgoods, 3/4 in Dia