Product#AYW 74701BT-01.50
MPN 5133-111
UPC053565489407
Description
McDonald® Ball Valve Corporation Stops come standard with 360 deg operating head and are designed for low turning torques and high pressures (300 psig). The PTFE coated ball is supported by two blow-out proof EPDM seals. The end piece joint is sealed with an EPDM O-ring and thread locker. There is no metal-to-metal contact which causes high torques. The bubble-tight feature at 300 psig makes these valves a better choice than a plug valve when test or operating pressures over 100 psig are expected. All McDonald® Ball Valve Corporation Stops are available with a wide variety of end connections. They are made in the United States of America and are manufactured to meet or exceed the AWWA C800 (latest revision) standard, except where noted.
A.Y. McDonald Ball Style Corporation Stop, 1-1/2 in Nominal, AWWA/CC Tap x T CTS Tube Compression 16P, 300 psig, Full Port, PTFE Coated Brass Ball, 2.15 in Top to Inlet Center, Brass Body, EPDM Softgoods
A.Y. McDonald Ball Style Corporation Stop, 1-1/2 in Nominal, AWWA/CC Tap x T CTS Tube Compression 16P, 300 psig, Full Port, PTFE Coated Brass Ball, 2.15 in Top to Inlet Center, Brass Body, EPDM Softgoods
- Brand:Â A.Y. McDonaldBall Material:Â PTFE Coated BrassBody Material:Â BrassEnd Style:Â AWWA/CC Tap x T CTS Tube Compression 16PNominal Size:Â 1-1/2 inPort Type:Â FullPressure Rating:Â 300 psigSeries:Â 74701BTSoftgoods Material:Â EPDMTop to Inlet Center:Â 2.15 in
- Brass components in contact with potable water conform to ASTM B584, UNS C89833 (latest revision) and identified with NL
- Blow-out proof EPDM port seals
- End piece joint sealed with an EPDM O-Ring and thread locker
- Insert stiffeners are required on all flexible plastic connections
- PTFE coated brass ball rotates 360 deg
- Operating head: standard
- EPDM O-ring/port seal
- McDonald® Ball Valve Corporation Stops come standard with 360 deg operating head and are designed for low turning torques and high pressures (300 psig). The PTFE coated ball is supported by two blow-out proof EPDM seals. The end piece joint is sealed with an EPDM O-ring and thread locker. There is no metal-to-metal contact which causes high torques. The bubble-tight feature at 300 psig makes these valves a better choice than a plug valve when test or operating pressures over 100 psig are expected. All McDonald® Ball Valve Corporation Stops are available with a wide variety of end connections. They are made in the United States of America and are manufactured to meet or exceed the AWWA C800 (latest revision) standard, except where noted.
A.Y. McDonald Ball Style Corporation Stop, 1-1/2 in Nominal, AWWA/CC Tap x T CTS Tube Compression 16P, 300 psig, Full Port, PTFE Coated Brass Ball, 2.15 in Top to Inlet Center, Brass Body, EPDM Softgoods